Same guys who cut the KR panel for me...Dusty Eagle wrote:I had the panel cut at Metal Centres in Booysens.If you need a number, please pm me.
It was their first attempt without a cad drawing being prepared, but with a bit of time and fine tuning, panel # 2 came out exremely well.
The first panel was a little extravagant, in that we made it both too high and too low. The hight interefered with the windscreen and the low came a little close to the knees, workable, but I changed that as not all the space on the bottom lip is needed.
The seat and floor boards & pedals were in before the panel. The seat has 40mm sponge in and even with the new panel angled forward, I comfortably reach the Garmin 296 in its panel doc at the top.
We havent tried with seat belts yet as those supplied do not fit.
http://www.metalscentre.edx.co.za/mwMain.aspx
What thickness Ali did you use?